Abstract

Dielectric response(DR) measurement has been deployed as a non-destructive and potential diagnostic method for moisture or aging condition of power system apparatuses. In order to promote the application of DR method, development of precise, easy-to-use and cost-effective testing devices is an urgent issue, in which accurate acquisition of the insulation current is critical. In this paper, a DR testing device which combine time-domain Polarization and Depolarization Current(PDC) and Frequency-Domain Spectroscopy(FDS), which are two major approaches for DR measurement, is developed. Firstly, the principle of PDC and FDS is introduced. Then the technical specification, hardware and software structure are demonstrated. In addition, using high input impedance PCI data acquisition card, phase lag error of the current measurement module is calibrated by measuring the voltage signal at both the input and the output ends of current measurement module. Finally, PDC and FDS test waveform of XLPE cable and bushing sample are demonstrated, and the effectiveness of this device is proved.

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call

Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.