Abstract

In the article the authors presented the construction of a contact device with an artificial unevenness on a vertical partition, which contributes to an increase in the specific contact area of the liquid and gas phases, in order to intensify the heat-storage process in the column apparatus, the experimental setup, the experimental procedure, the results of the experiments and the conclusions on the work. The experiments demonstrated the effect of the geometric parameters of the working section (width of the working area, height of the working area, bending radius of the working section) of the artificial unevenness of the partition of the contact device on the spreading area of the film and on the deviation of the liquid from the axis of the edge of the working section. The most effective ratio of the diameter of the drain of the liquid to the width of the working section is shown and the influence of the height of the working area on the efficiency of the proposed design of a jet-film contact device with an artificial unevenness on a vertical partition.

Highlights

  • In the article the authors presented the construction of a contact device with an artificial unevenness

  • which contributes to an increase in the specific contact area

  • The experiments demonstrated the effect of the geometric parameters of the working section

Read more

Summary

Introduction

Одним из конструкционных решений является разработка струйно-пленочных контактных устройств с развитой поверхностью, способствующих повышению удельной площади контакта жидкой и газовой фаз в колонных аппаратах. С целью исследования влияния геометрических параметров рабочего участка контактного устройства (при h=10 и 15 мм, l=5; 10 и 15 мм, R=5 мм) на растекание жидкости вдоль поверхности вертикальной перегородки была разработана экспериментальная установка Экспериментальная часть и обсуждение результатов исследований Вода, вытекающая из отверстия D=10 мм емкости 1 со скоростью wводы=0,22 м/с, стекала по месту сгиба рабочего участка контактного устройства в емкость для сбора жидкости 3.

Results
Conclusion
Full Text
Published version (Free)

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call