Development of stress birefringence and flow patterns during mold fillin and cooling

Abstract

AbstractAn experimental study was carried out to investigate the development of stress birefringence patterns of molten polymer during the mold filling and cooling operation. For this study, a rectangular mold cavity with glass windows on both sides was constructed, which permitted us to record on a movie film the changes in stress birefringence patterns in the mold cavity during the molding operation, using a circular polariscope. The mold was equipped with an automatic relay system which closes the shut‐off valve when the pressure in the mold cavity reaches a predetermined value. The mold was also equipped with both heating and cooling devices, so that either isothermal or non‐isothermal injection molding could be carried out. The mold temperature was controlled by thermistor regulated controllers. During the entire cycle of the molding operation, the mold cavity pressure was continuously recorded on a chart recorder, using a melt pressure transducer. The present study shows how molding conditions (namely, injection pressure, melt temperature, mold temperature) influence the distribution of stress birefringence patterns in a molten polymer while it is being injected into, and cooled in, a rectangular mold cavity.