Development of Spring Hinge Models to Simulate Structural Elements of Spherical Graphite Reinforced Concrete

Abstract

The goals of the study were the formation of a model of concentrated plasticity based on spherical graphite fibers. The goal was to present indicators of the cyclic behavior of structural elements due to the lack of consideration in modern scientific research of the issue of increasing the technical level and reliability of structures due to the addition of innovative materials during the development of structural elements. Taking into account the fundamental shortcomings in construction in the conditions of installing an excess amount of reinforcement, as one of the main mechanisms for achieving strength and reliability. The aim of the study was to develop a method of improving the quality of structural elements using innovative materials through building spring hinge models. The study involved the mathematical simulation, comparison, and system analysis. The result of the work is a developed spring hinge model for simulating reinforced concrete structural elements. The work emphasizes that the obtained experimental model converges to reference data and does not reflect a significant error with the increased number of cycles. It is emphasized that the model degrades with significant calibration, while the numerical strength and hysteresis behaviour matches the experimental data at higher deformation levels. The model of concentrated plasticity based on spherical graphite fibers was developed for the range of indicators of the cyclic behaviour of structural elements. The main characteristics of the reinforced concrete structural elements under consideration in the framework of the study are provided in a table in order to visually separate the groups of structures according to the main parameters. A non-linear model of a spring hinge is graphically shown, which shows the moment of movement of the spring when a monotonous load is applied. An urgent need to build a system of indicators of the structural elements’ cyclic behaviour was emphasized. A concentrated plasticity model based on spherical graphite fibers was built for this purpose. A beam-column was chosen as a reinforced concrete structure, which is based on a zero-length spring pivot hinge at the end of each individual element. This spring pivot hinge is a uniaxial material model with a moment-rotation dependency. Such a dependency is the fundamental basis of the spring hinge model used to simulate reinforced concrete structural elements. The comparison chart of reference and cyclic strength of a spherical graphite reinforced concrete beam is presented graphically. Prospects for further research involve the development of an empirical system of equations depending on the section geometry and the properties of the structure material based on prognostic variables from the list of potential variable characteristics.