Abstract
The results on the research and development of small polymer electrolyte fuel cell stacks, including the assembly of single cell. 6-cell and 21-cell modules, are described. The important characteristics of the systems are: (i) membrane and electrode assemblies were made with Nafion ® 115 and 117 membranes and particularly low catalyst loading electrodes presenting a geometric area of 20 cm 2 and a catalyst loading of 0.4 mg Pt/cm 2: (ii) bipolar plates were fabricated using a nonporous graphite material in which a series/parallel flow field was machined out: (iii) external distribution of gases to the cells was done using parallel manifolding; (iv) cooling systems were tested employing water/air cooling plates distributed every three cells throughout the stack; (v) the reactant gases were externally humidified using temperature controlled humidification bottles. Testing of the stacks was conducted in a specially designed test station employing nonpressurized H 2/O 2 reactants and measuring the individual and the overall cell voltage vs. current under several conditions for the overall system operation.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.