Development of Scallop Cut Type Damper Seal for Centrifugal Compressors

Abstract

This paper deals with a new type of damper seal developed for a high-pressure centrifugal compressor. Honeycomb seals and hole-pattern seals are popularly used as damper seals and provide superior rotordynamic damping characteristics. Honeycomb seals are expensive because the manufacturing process is complex. Hole-pattern seals are easier to manufacture, but they are still expensive. Use of a scallop pattern is one way to reduce manufacturing cost and time. A new seal that has a scallop pattern and small teeth on the stator surface is proposed. This pattern is cut on the stator surface using a disc type tool. To estimate the rotordynamic coefficients of this new seal, a bulk flow model code that is based on a two-control-volume model developed by Matsuda for labyrinth seals was newly developed. This model uses the Hirs model for the viscous shear stresses. The friction factor coefficients for the rotor surface, the stator surface and the surface between the two control volumes were determined by CFD steady analysis. The rotordynamic coefficients can also be obtained by using CFD perturbation analysis. The high accuracy of the bulk flow model was demonstrated by comparing its results with CFD perturbation analysis results. In the perturbation analysis, the whirling motion was treated as a steady state problem by using a rotating frame of reference. For the damper seal, the rotor surface and its neighboring region were treated with a rotating frame of reference and the neighboring region of the stator was treated with a stationary frame of reference. The damping property of the new seal was evaluated by conducting rotor stability tests using a high-pressure compressor with an electromagnetic exciter. The new seal equipped with swirl brakes was used for the balance piston of the compressor. Stability was evaluated by exciting the rotor during operation and identifying the eigenvalues of the rotor. The experimental results showed that the new seal increases damping. Comparison of the damping effect with calculations based on the bulk flow analysis showed good agreement.