Development of remaining wall thickness measurement system for boiler wall tube using gamma scattering technique

Abstract

In this study, the General Monte Carlo N-Particle version 5 (MCNP5) simulation of the measuring system for the remaining thickness of the wall tube using gamma scattering technique is performed to investigate the applicability of this technique and to find the optimum geometrical setup for the experimental setup. The numerical results show that the optimal geometry condition to provide the highest ratio between the gamma flux changes per thickness variation, namely, the measurement sensitivity, is the alignment of the source incidence angle of 30 degree and detector scattering angle of 30 degrees. Sequentially, the preliminary experiment of thickness measurement system for the tube using the gamma scattering technique is conducted based on the selected geometrical test setup by the simulation. It is found that the experimental results have generally a good agreement with the calculated results. Conclusively, it is suggested that the gamma scattering technique has a potential method to measure the remaining wall thickness in the boiler wall tube.