Abstract
The extrusion foaming of recycled polyethylene through different foaming agents has been studied. Cellular structures were obtained in a single screw extruder with different grades of polyethylene (low and high density), using recycled gypsum and a commercial foaming agent (azodicarbonamide). Differential scanning calorimetry and thermogravimetric analysis were used to characterize the transition temperatures of the polyethylenes used, and the dissociation temperature of the foaming agents. The effect of processing conditions on the density of extrudates was studied. The pressure developed during extrusion and the residence time in the die was shown to influence the final density and cellular structure of foamed polyethylene. The results indicate that a higher polymer viscosity corresponds a lower density of the foamed product. The formation of the gaseous phase should take place at temperatures immediately higher than the melting temperature range of the polymer, in order to allow complete dissociation of the foaming agent in highly viscous molten polymer.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
