Abstract
This study proposes a measurement system that comprises an e-Tape water level sensor, Arduino and XBee. The system was considered a success because of the linear relation between measured voltage signals and water depths obtained by it. This linearity was essential because Arduino does not have non-linear calculation ability. As a result, the numerical order of RMSE in measuring water depth using this system was obtained as 3.52 mm. For measuring water consumption for 1 day at the standard scale of paddy fields in Japan, water consumption can be estimated using the system below non-flowing water surfaces. However, when there is water flow, it will be difficult to estimate water consumption because discharge errors may be cumulative.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.