Development of Novel High Capacity Fluoride Ion Battery Cathode Utilizing Anion Redox of Sulfur

Abstract

All-solid-state fluoride-ion batteries (FIBs), which are based on the shuttling of fluoride ions, have been considered as one of the promising alternates for next-generation energy storage devices because of high theoretical energy density and safety. Benefiting from the multi-covalent fluorination process, metal/metal fluorides (M/MFx) have been firstly utilized as electrode materials for FIBs with high theoretical energy densities.[1] However, M/MFx systems suffer from exceptionable volume expansion upon fluorination process due to the close-packed metal atoms, which would cause blockage of the F- diffusion pathway, resulting in devastating damage to the electrode-electrolyte interfaces. To solve these problems, cathode materials that utilize topotactic fluoride ion intercalation reactions, similar to the electrode materials applied in lithium-ion secondary batteries, are being developed.[2] Cathode materials that utilize topotactic intercalation of fluoride ions are often composed of heavier elements than the cathodes of lithium-ion batteries that use the same type of reaction mechanism, and effective anion redox is required if capacity is to be increased beyond that of lithium-ion secondary batteries.In this research, we investigated Sr2F2Fe2OS2 (SFFOS) compound with a layered structure as a novel cathode material for all-solid-state FIBs, and evaluated its electrochemical properties and elucidated the charge compensation mechanism using anion redox of sulfur.SFFOS was synthesized by a solid-state reaction under vacuum environment using SrF2, SrO, Fe, and S.[3] SFFOS/La0.9Ba0.1F2.9/vapor grown carbon fiber (VGCF) was used as the composite cathode, La0.9Ba0.1F2.9 as the electrolyte and Pb/PbF2/ La0.9Ba0.1F2.9/VGCF as the composite anode to construct the electrochemical cell. Charge-discharge measurements were carried out in the cut-off voltage range of -1.5 to 1.5 V at 140°C. Ex-situ X-ray Diffraction (XRD), X-ray absorption spectroscopy (XAS) measurements of Fe K-edge, S K-edge, O K-edge and F K-edge were carried out under different state of charge during the 1st and the 2nd cycle.SFFOS showed reversible intercalation/de-intercalation of fluoride ions and a capacity of ~6.1 fluoride ions per unit cell (403 mAh g-1). The charge compensation mechanism was revealed for SFFOS by XAS measurements, where S redox contributed to the whole voltage range from -1.5 V to 1.5 V vs. Pb/PbF2, and Fe+2/+3 redox contributed from the middle SOC. The S-S dimers were formed upon charging, which was similar to the trapped O2 molecules observed in lithium-excess metal oxide during charge process[4]. Not only can the F- anions insert around Fe to form Fe-F bonds, but the excess F- anions can also occupy the Sr-S interstitial layers in the original lattice. Compared to the Fe-based layered oxide Sr3Fe2O5, the Fe-based oxysulfide SFFOS showed a lower average voltage but a higher specific capacity. We believe that this study could provide a new understanding of sulfur-based charge compensation and electrochemical fluorination reactions. Reference s : [1] D. Zhang, K. Yamamoto, Y. Uchimoto et al., J. Mater. Chem. A, 2021, 9, 406–412.[2] Y. Wang, K. Yamamoto, Y. Uchimoto, et al., Chem. Mater., 2022, 34, 609–616.[3] Kabbour H, Janod E, Corraze B, et al ., J. Am. Chem. Soc., 2008, 130(26): 8261-8270.[4] R. A. House, P. G. Bruce, et al., Nat. Energy 2020, 5, 777–785. Figure 1