Development of low-noise high-speed analog ASIC for X-ray CCD cameras and wide-band X-ray imaging sensors

Abstract

We report on the development and performance evaluation of the mixed-signal Application Specific Integrated Circuit (ASIC) developed for the signal processing of onboard X-ray CCD cameras and various types of X-ray imaging sensors in astrophysics. The quick and low-noise readout is essential for the pile-up free imaging spectroscopy with a future X-ray telescope. Our goal is the readout noise of 5e−r.m.s. at the pixel rate of 1Mpix/s that is about 10times faster than those of the currently working detectors. We successfully developed a low-noise ASIC as the front-end electronics of the Soft X-ray Imager onboard Hitomi that was launched on February 17, 2016. However, it has two analog-to-digital converters per chain due to the limited processing speed and hence we need to correct the difference of gain to obtain the X-ray spectra. Furthermore, its input equivalent noise performance is not satisfactory (>100μV) at the pixel rate higher than 500kpix/s. Then we upgrade the design of the ASIC with the fourth-order ΔΣ modulators to enhance its inherent noise-shaping performance. Its performance is measured using pseudo CCD signals with variable processing speed. Although its input equivalent noise is comparable with the conventional one, the integrated non-linearity (0.1%) improves to about the half of that of the conventional one. The radiation tolerance is also measured with regard to the total ionizing dose effect and the single event latch-up using protons and Xenon, respectively. The former experiment shows that all of the performances does not change after imposing the dose corresponding to 590years in a low earth orbit. We also put the upper limit on the frequency of the latch-up to be once per 48years.