Development of isotropic compatible HDPE/PP blends for structural applications

Abstract

AbstractIn an attempt to provide superior products for the structural applications, this study aimed at preparing isotropic compatible high density polyethylene (HDPE)/ polypropylene (PP) blends without the use of the expensive compatibilization technique. Morphological and structural characterizations of the homopolymers and blends were carried out. In addition, some of the structurally important mechanical and thermal properties were characterized. Such characterizations were performed to investigate whether or not the blends are compatible and therefore acceptable for the structural applications. Scanning electron microscope (SEM) micrographs of the blend samples indicate that the interfacial adhesion between HDPE and PP phases is intimate in the 5/95 HDPE‐PP, good in the 85/15 HDPE‐PP and 95/5 HDPE‐PP, fair in the 30/70 HDPE‐PP and very poor in the 50/50 HDPE‐PP. Similarly, mechanical and thermal responses of the first three blends are remarkable. The 30/70 HDPE‐PP blend displays a fairly good performance. Whereas, the properties of the 50/50 HDPE‐PP blend are very poor. This decides that the first three blends are compatible and, therefore, structurally attractive materials. The fourth is partially compatible and, as a consequence, can be rather acceptable for the structural applications. However, the fifth is incompatible and, of course, is not acceptable for such applications. On the other hand, SEM micrographs and differential scanning calorimetry results indicate that the crystalline structures of individual polymers are appreciably affected by blending. Additionally, the study reveals that the end use performance of blends is strongly dependent on the crystalline structure changes occurring in each component due to blending as well as the compatibility between the blend components. © 2009 Wiley Periodicals, Inc. J Appl Polym Sci, 2010