Abstract
PMAC motion controllers serve not only as a receiver of the orders from CNC systems of many kinds, but also as a controller of the motion of machine tools’ axles. With G83 as an example, a code commonly seen in the processing cycle of deep holes in CNC machining centers, it is advisable to come up with a method to write a special set of subprograms to invoke PMAC motion controllers with the application of G-code. Based on the method, case programing and machining simulation can be launched. Experiments justify that the method obtained can realize the compiling of fixed cycles with the use of G-code and, in turn, boast substantial significance in the development of open CNC processing machine tools.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
