Abstract
This paper presents the design and the development of an indoor lighting control based on fuzzy logic controller (FLC). The objective of this study is to demonstrate how the FLC can optimize the lighting based on indoor and outdoor lighting environments. The FLC system uses two inputs with Light Dependent Resistors (LDR) as a sensor at indoor and outdoor lighting environments. The output is Light Emitting Diodes (LEDs) to provide lighting at the room automatically. The Pulse Width Modulation (PWM) is used to adjust the LEDs lighting in the room. FLC has successfully demonstrated performance to control the output of LEDs as needed. If the LDR 1 input as indoor sensor shows dim, it will automatically turn on brightly. The MSE values for simulation and experiment of LDR 1 and LDR 2 were 34.42 and 30.11 respectively. The results of FLC performance in the simulation work are further validated by an experimental work. Experimental results show similarities compared to the simulation results.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callMore From: TELKOMNIKA (Telecommunication Computing Electronics and Control)
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
