Development of functionalized poly(lactide) films with chitosan via SI-SARA ATRP as scaffolds for neuronal cell growth

Abstract

Polylactic acid (PLA), a polymer derived from renewable resources, is gaining increasing attention in the development of biomedical devices due to its cost-effectiveness, low immunogenicity, and biodegradability. However, its inherent hydrophobicity remains a problem, leading to poor cell adhesion features. On this basis, the aim of this work was to develop a method for functionalizing the surface of PLA films with a biopolymer, chitosan (CH), which was proved to be a material with intrinsic cell adhesive properties, but whose mechanical properties are insufficient to be used alone. The combination of the two polymers, PLA as a bulk scaffold and CH as a coating, could be a promising combination to develop a scaffold for cell growth. The modification of PLA films involved several steps: aminolysis followed by bromination to graft amino and then bromide groups, poly(glycidyl methacrylate) (PGMA) grafting by surface-initiated supplemental activator and reducing agent atom transfer radical polymerization (SI-SARA ATRP) and finally the CH grafting. To prove the effective adhesive properties, conjugated and non-conjugated films were tested in vitro as substrates for neuronal cell growth using differentiated neurons from human induced pluripotent stem cells. The results demonstrated enhanced cell growth in the presence of CH.