Abstract
Additive manufacturing technology like laser powder bed fusion represents a valid alternative for the production of ferromagnetic cores. In this study, two grades of steel were considered, with standard (3.0 wt%) and high (6.5 wt%) Si content. The study is aimed at optimizing the process parameters in order to obtain components suitable for magnetic applications. Moreover, the effect of post-production annealing heat treatment on the microstructure evolution is investigated. The investigation included microstructural analysis by optical microscope, dynamic scanning calorimetry analysis and electro-magnetic measurements on samples with optimized geometry. Results shows that both types of steel can be produced free from defects. Even if the magnetic behaviour of FeSi6.5 samples by AM do not fully reproduces that obtained on electrical steels manufactured by standard process, it appears quite promising. In this framework the optimization of post-production processes represents a promising challenge to meet market demands.Graphical abstract
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
