Development of FDM 3D-printed tablets with rapid drug release, high drug-polymer miscibility and reduced printing temperature by applying the acid-base supersolubilization (ABS) principle

Abstract

Some of the major issues with the development of FDM 3D printed tablets are slow drug release, lack of drug-polymer miscibility, high processing temperature, and poor printability. In this investigation, these issues were addressed by using a novel physicochemical principle called acid-base supersolubilization (ABS) previously developed in our laboratory. The aqueous solubility of a basic drug, haloperidol, was increased to ~300 mg/g of solution by adding glutaric acid, and, upon drying, the concentrated solutions produced amorphous materials. Similar amorphous systems could also be produced by heating haloperidol-glutaric acid mixtures. Filaments for 3D printing were prepared by melt extrusion of formulations containing 15% w/w haloperidol and 10.5% glutaric acid (1:2 M ratio) along with 74.5% polymers, such as Kollidon® VA64 alone or its mixtures with Affinisol™ 15cP. Filaments could be extruded and printed at low temperatures of 115 and 120 °C, respectively. Haloperidol was fully miscible in the formulations because of the acid-base interaction and formed amorphous systems even at higher drug loads. Although filaments of haloperidol-Kollidon® VA64 mixtures by themselves cannot be printed, the printability of formulation improved such that those containing glutaric acid were printable. Drug release rates from the formulations at pH 2 and 6.8 were rapid and complete.