Development of design storm hyetographs in hyper-arid and arid regions: case study of Sultanate of Oman

Abstract

The temporal distribution of the design storm is an important input in hydrological models. This research aims to develop design storm profiles representative of arid and hyper-arid areas based on actual storm recordings. Two hundred thirty-six rainfall storms were collected from seventeen rainfall gauges that cover the coastal zone of Oman for the period from 1993 to 2007. Storms were classified into four categories according to their total durations. Design storm hyetographs were derived from raw rainfall records for all four categories using the Alternating Block Method (ABM) and were also computed by ABM applied on the Intensity-Duration-Frequency (IDF) curves. Both design storm profiles were compared and it was found that the ABM_IDF storm profiles were equivalent to the four ABM_Storms profiles from a practical point of view as they produce similar peak discharges. The storm profiles developed in the current research were also compared to the commonly used Soil Conservation Service (SCS) dimensionless distributions and the UK50 storm profiles. The results showed that the most conservative commonly used SCS type II and the UK50 summer profiles are not safe to be used in design purposes in arid and hyper arid regions, despite their wide utilization in many codes of practice in these regions. The study recommends using the newly developed dimensionless storm profiles derived from the actual records.