Development of density measurement for metals at high pressures and high temperatures using X-ray absorption imaging combined with externally heated diamond anvil cell

Abstract

A technique for density measurement under high pressure and high temperature was developed using the X-ray absorption imaging method combined with an externally heated diamond anvil cell. The densities of solid and liquid In were measured in the pressure and temperature ranges of 3.2–18.6GPa and 294–719K. The densities obtained through the X-ray absorption imaging method were in good agreement (less than 2.0% difference) with those obtained through X-ray diffraction. Based on the measured density, the isothermal bulk modulus of solid In is determined as 48.0±1.1−40.9±0.8GPa at 500K, assuming K′=4 to 6. The compression curve of liquid In approaches that of solid In at higher pressures and does not cross over the solid compression curve in the measurement range. The present technique enables us to determine the densities of both solids and liquids precisely in a wide pressure and temperature range.