Abstract
A cutting simulator based on energy approach is implemented in a process planning system, which determines the process parameters in the milling operations. The required data for the analysis is identified to minimize the discrepancy between the calculated and the measured cutting force in some reference operations. The identification function in the implemented simulator is applied to the process planning system as a module of self-management of the database. Some case studies, then, are shown to verify the simulation module in the process planning system. An application of the simulator is presented to determine the applicable cutting conditions according to the machining requirements.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callMore From: Proceedings of International Conference on Leading Edge Manufacturing in 21st century : LEM21
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
