Development of blood collection tubes for glucose measurement using adenosine 3-phosphate and sodium fluoride as glycolytic inhibitors.

Abstract

Blood collection tubes with sodium fluoride (NaF) added as a glycolytic inhibitor are widely used for glucose measurement. However, the glycolytic inhibitory effects of NaF are insufficient, and decreases in glucose levels over time after blood collection have become a problem. Blood from a volunteer collected using an NaF tube was used to compare the glycolysis inhibitory abilities of ATP and ADP. Blood samples from 10 volunteers were collected in NaF tubes and NaF tubes with added ATP (NaF-ATP tubes). The stability of glucose and haemoglobin (Hb)A1c after whole-blood storage from immediately after blood collection to 24 h later was compared. ATP and ADP had similar inhibitory effects on glycolysis, but ATP was selected as an additive for blood collection tubes because ADP was more haemolytic than ATP. We verified the ability of NaF blood collection tubes supplemented with ATP to inhibit glycolysis. Mean (± standard deviation) glucose levels (n=10) after storage for 24 h after blood collection decreased to -9.0 ± 2.7 mg/dL (-0.50 ± 0.15 mmol/L) in conventional NaF tubes. NaF-ATP(20) tubes with 20 mg (0.036 mmol) ATP added showed a reduced decrease, with a mean of -5.8 ± 2.9 mg/dL (-0.32 ± 0.16 mmol/L). NaF-ATP tubes also had no effect on HbA1c measurement. This study reports on a blood collection tube that enables the measurement of glucose and HbA1c. Based on the results of validation, we conclude that NaF-ATP tubes can reduce decreases in glucose over time in stored whole blood compared to conventional NaF tubes.