Development of Besifloxacin HCL Loaded Ocular İn Situ Gels; In Vitro Characterization Study

Abstract

Objective: The aim of this study is to develop in situ gel formulations containing besifloxacin hydrochloride are heat triggered, which are prepared by using different poloxomer and derivatives different polymers that will change the gelling temperature to increase corneal contact time, regulate drug release, improve ocular bioavailability and increase patient compliance increase mucoadhesion.
 Material and Method: Various concentrations of poloxamer 188 (P188) and poloxamer 407 (P407) were used to create the in situ forming gels. To increase the gel's capacity for bioadhesion, mucoadhesives such hydroxypropylmethyl cellulose (HPMC) or hydroxyethyl cellulose (HEC) were included in the formulations. Drug release in vitro, sol-gel transition temperature, rheological behavior, pH, clarity, and mucoadhesion force were all assessed for the produced formulations. 
 Result and Discussion: The developed formulations' gelation temperatures ranged from 29 to 35°C. The preparations' viscosity and mucoadhesion force increased with increasing P407, HPMC, and HEC concentrations. Besifloxacin HCl forms in situ gel formulas with K1, K2, K3, and K6 suited for mucoadhesion characteristics, gelation temperature, and viscosity. These formulations exhibit pseudoplastic flow. Increasing polymer concentrations resulted in a reduction in the burst release of the formulations. However, at the end of 6 hours, drug release was finished in all formulations. The results show that in situ gels containing P407 and P188 show promise for besifloxacin HCl application