Development of an automated 3D metallography system and some first application examples in microstructural analysis

Abstract

Abstract Traditional metallography relies on the imaging of individual section planes. However, conclusions as to spatial shapes and microstructural arrangements can only be drawn to a limited extent. The idea to reconstruct three-dimensional microstructures from metallographic serial sections is therefore obvious and not at all new. However, the manual process of preparing a great number of individual sections and assembling them into image stacks is time-consuming and laborious and therefore constitutes an obstacle to frequent use. This is why the Federal Institute for Materials Research and Testing, or BAM for short (Bundesanstalt für Materialforschung und -prüfung), is developing a robot-assisted 3D metallography system performing the tasks of preparation and image acquisition on a metallographic section fully automatically and repeatedly. Preparation includes grinding, polishing and optional etching of the section surface. Image acquisition is performed using a light optical microscope with autofocus at several magnification levels. The obtained image stack is then pre-processed, segmented and converted to a 3D model resembling a microtomographic image, but with a higher lateral resolution at large volumes. As opposed to tomographic techniques, it is possible to perform traditional chemical etching for contrasting. The integration of a scanning electron microscope is in the planning stages. Studies conducted so far have demonstrated the possibility of visualizing hot gas corrosion layers, gray cast irons and ceramic-based microelectronic structures (vias).