Development of an analytical method for the simultaneous determination of 15 carcinogenic polycyclic aromatic hydrocarbons and polycyclic aromatic nitrogen heterocyclic compounds. application to diesel particulates.

Abstract

A new method enabling the determination of 15 priority carcinogenic polyaromatic compounds (PAC) proposed by the US National Toxicology Program (NTP) has been developed and applied to diesel exhaust particulates (DEP). The clean-up procedure consists of solid-phase extraction (SPE) and HPLC fractionation on silica phases followed by liquid-liquid extraction and chromatography on a polyvinylbenzene copolymer column. The method gives good recoveries for all PAC studied except dibenzo[a,j]acridine and dibenzo[a,h]pyrene, for which recovery values are below 80%. The use of GC-MS ion trap and its capacity to achieve single-ion storage enhanced the sensitivity of the method, enabling the detection of high-molecular-weight PAH in the low ng g(-1) concentration range. Intermediate polarity GC columns, e.g. BPX-50 or equivalent, enabled better separation, when applied to DEP analysis, than the generally used DB-5 apolar phase. This is observed mainly for separation of isomeric compounds belonging to the benzofluoranthene and dibenzopyrene families. The application of this method to DEP sampled from the exhaust of a diesel engine and in confined locations such as a tunnel has shown that all PAH of the NTP list could be detected, except dibenzo[a,h]pyrene. No dibenzacridine or dibenzocarbazole could be detected in such matrices. The method is sufficiently sensitive to be applicable to environmental exposure measurements in occupational health surveys.