Abstract
A procedure for the construction of reference circles of the profile of the axial section of a test shaft or hole, the maximum inscribed circle and minimum circumscribed circle, along with circles that specify the boundaries of a ring of minimal width, is proposed. The radii and coordinates of the centers of the circles are found through minimization or maximization of a corresponding functional constructed on the basis of the coordinates of the points of the profile. The construction procedures presented are implemented in the Mathcad program package. The results obtained may be used to determine deviations from roundness, in particular, in the development of mathematical software of measuring instruments.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.