Development of a Quality Control System Using Modal Analysis to Evaluate a Multi-Point Projection Welding Process.

Abstract

The article presents the results of the development and research regarding the application of modal analysis to the evaluation of a multi-point projection welding process. The quality control system is based on the information provided by modal analysis for the entire welding station after the previously completed welding process. The research is carried out due to the lack of an effective method for assessing the course of the multi-spot projection welding process in the case of a single current circuit passing through many points at the same time. A study of the applicability of modal analysis in investigating the quality of a multipoint joint was conducted for four DIN 928 nuts welded to a steel profile. The aim of the study was to determine the influence of weld defects on the displacement of resonant frequencies. To realize the objective, the dynamic properties of the entire welding station, including the sample in the frequency domain, were investigated. In the first stage of the study, a finite element method was used to perform modal analysis and examine the form of vibrations for the individual natural frequencies of the welding fixture including the sample. Then, quality verification using the dynamic resistance method was performed, which was compared later with the modal approach. The last stage of the study was to conduct modal analysis in the frequency domain to verify the numerical studies.