Development of a novel two-dimensional(2D) three-way(3W) fuel flow control servo valve with constant pressure difference

Abstract

To solve the problems of large volume, and low integration of traditional electro-hydraulic servo valve with constant pressure differential fuel metering device, a new two-dimensional three-way constant pressure differential fuel flow control servo valve (2D3WFFCSV) is developed. It innovatively adopts the advantages of lightweight of “two-dimensional hydraulic technology”, The constant differential pressure function and flow regulation function are integrated into a two-dimensional (2D) main spool with two degrees of freedom (rotational and axial degrees of freedom). The flow control process of 2D3WFFCSV is as follows: firstly, the armature of the torque motor and the two-dimensional piston are coaxially installed at the end of the two-dimensional piston, so the torque motor can directly drive the two-dimensional piston to rotate; secondly the “hydraulic servo screw mechanism”, which can amplify the power, is used to drive the two-dimensional piston to move in line; Finally, a pair of conversion mechanisms (roller group and spiral track conversion mechanism) are converted into the angular displacement of 2D main spool to control the area of flow valve port. The axial degree of freedom of 2D main spool realizes the function of constant differential pressure. To improve the flow control accuracy of the servo valve, the axial position of the 2D piston is detected by the linear displacement sensor (LVDT), and the signal is transmitted to the controller to realize the closed-loop control. To explore its open-loop characteristics, the mathematical models of torque motor, two-dimensional piston and main spool are established to obtain its open-loop transfer function. Then the AMESIM simulation model is built. To optimize the design of the system, through the dynamic simulation of the system, the influence of key parameters on the dynamic response of the system can be studied. An experimental study is carried out to verify the design feasibility of the servo valve. The experimental results show that under the condition of no-load and full-scale input, the closed-loop delay of the servo valve is 1.84%, the linearity is 2.14%, the step response time is 43 ms, and the dynamic frequency response is 38 Hz. The newly developed 2D3WFFCSV has the advantages of high integration, small size, light weight (801.5 g) and high response and control accuracy. It can replace the constant differential pressure, metering valve and hydraulic servo valve in the aeroengine fuel regulator.