Abstract
BackgroundArray-based comparative genomic hybridization (CGH) and gene expression profiling have become vital techniques for identifying molecular defects underlying genetic diseases. Regardless of the microarray platform, cyanine dyes (Cy3 and Cy5) are one of the most widely used fluorescent dye pairs for microarray analysis owing to their brightness and ease of incorporation, enabling high level of assay sensitivity. However, combining both dyes on arrays can become problematic during summer months when ozone levels rise to near 25 parts per billion (ppb). Under such conditions, Cy5 is known to rapidly degrade leading to loss of signal from either "homebrew" or commercial arrays. Cy5 can also suffer disproportionately from dye photobleaching resulting in distortion of (Cy5/Cy3) ratios used in copy number analysis. Our laboratory has been active in fluorescent dye research to find a suitable alternative to Cy5 that is stable to ozone and resistant to photo-bleaching. Here, we report on the development of such a dye, called HyPer5, and describe its' exceptional ozone and photostable properties on microarrays.ResultsOur results show HyPer5 signal to be stable to high ozone levels. Repeated exposure of mouse arrays hybridized with HyPer5-labeled cDNA to 300 ppb ozone at 5, 10 and 15 minute intervals resulted in no signal loss from the dye. In comparison, Cy5 arrays showed a dramatic 80% decrease in total signal during the same interval. Photobleaching experiments show HyPer5 to be resistant to light induced damage with 3- fold improvement in dye stability over Cy5. In high resolution array CGH experiments, HyPer5 is demonstrated to detect chromosomal aberrations at loci 2p21-16.3 and 15q26.3-26.2 from three patient sample using bacterial artificial chromosome (BAC) arrays. The photostability of HyPer5 is further documented by repeat array scanning without loss of detection. Additionally, HyPer5 arrays are shown to preserve sensitivity and data quality from gene expression experiments.ConclusionHyPer5 is a red fluorescent dye that behaves functionally similar to Cy5 except in stability to ozone and light. HyPer5 is demonstrated to be resistant to ozone at up to 300 ppb, levels significantly higher than commonly observed during summer months. Consequently, HyPer5 dye can be used in parallel with Cy3 under any environmental conditions in array experiments.
Highlights
Array-based comparative genomic hybridization (CGH) and gene expression profiling have become vital techniques for identifying molecular defects underlying genetic diseases
HyPer5 is a red fluorescent dye that behaves functionally similar to Cy5 except in stability to ozone and light
HyPer5 is demonstrated to be resistant to ozone at up to 300 ppb, levels significantly higher than commonly observed during summer months
Summary
Array-based comparative genomic hybridization (CGH) and gene expression profiling have become vital techniques for identifying molecular defects underlying genetic diseases. Regardless of the microarray platform, cyanine dyes (Cy3 and Cy5) are one of the most widely used fluorescent dye pairs for microarray analysis owing to their brightness and ease of incorporation, enabling high level of assay sensitivity. Combining both dyes on arrays can become problematic during summer months when ozone levels rise to near 25 parts per billion (ppb). To circumvent Cy5 signal loss from ozone exposure, Branham et al have proposed an engineering solution based on installation of a carbon-filtration system to eliminate ozone inside laboratories [7] While these systems can be effective in depleting ozone, they are expensive and difficult to engineer in open laboratory spaces allowing ozone levels to fluctuate posing continuous risk to data quality from often expensive arrays. Like ozone, photobleaching of Cy5 leads to reduction of absolute signals obtained from the arrays
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have