Abstract
A new technique was developed for measuring the thickness of can coatings applied to a metal substrate. A metal disc with a known radius creates a small indent in the coating, stopping exactly when the coating thickness is cut through. The indent length is employed to calculate the coating thickness. Accurate measurement of thin films is achieved as the indent is much larger than the respective film thickness. The thickness of epoxy phenolic coatings on tinplate were measured and the results were validated by micrographic cross section analysis and by confocal laser scanning microscopy (CLSM). The coating thicknesses measured using the indentation method coincide with the film thicknesses measured by CLSM, whereas discrepancies were observed using the micrographic cross section analysis. The new technique, presented in this paper, uses simple equipment, is inexpensive, fast and easy to use, and is suitable for film thickness measurements in laboratories and production plants.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
