Abstract
The aim of this study is to develop of a new binder using entirely by-products for a production of CLSM. The new cementless binder, tentatively named Fa-RmLG, was made from fly ash (Fa), lime (L), gypsum (G) and red mud (Rm). Various CSLM mixtures were produced with pond ash and different proportions of the new cementless binder Fa-RmLG. To assess the technical feasibility of this cementless binder in CLSM, three phases corresponding with three mix proportions were performed in this study. A preliminary proportion (phase I) was conducted to evaluate the engineering properties of five proposed CLSM mixtures in which the ratio of gypsum to red mud (G/Rm) varied in the range of 0.4–6.0. Subsequently, the best CLSM mixture was selected to be the control mix for a further study, which investigated the effect of fly ash content (phase II) and lime content (phase III) on the engineering properties of all CLSM mixtures in these phases. The obtained results showed that the engineering properties (flowability, bleeding, setting time, unconfined compressive strength, and microstructural analysis) and environmental impacts (corrosivity, heavy metals) of CLSM made with the proposed cementless binder met the ACI 229R requirements through a control of the cementless binder proportions. In conclusion, it was found a feasibility of using the developed Fa-RmLG binder for the production of CLSM.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have