Abstract
Abstract This paper reports the development of a semi-automatic microgripping system that consists of a microgripper and an x, y, z positioning system. The microgripper has two 1DOF fingers fabricated by an amorphous, soft magnetic material and is actuated electromagnetically. The microgripper is embedded in the 3DOF positioning system with the help of a stainless steel holder under an angle, which is manually adjusted, in respect to the working field. The position of the microgripper is observed optically and by three digital indicators 1 from Mitutoyo, which offer easy reading and continuous position tracking. All axes are actuated by step motors which allow precise positioning of the microparticles under manipulation. The microgripping system was tested in pick and place cases, under an optical microscope in atmospheric conditions. Optical fibres (125 μm in diameter) and bonding wires (50 μm in diameter) were handled. The temperature on the actuator, on the microgripper fingers and on the microgripper tips during manipulation was measured using K type (Ni/CrNi) thermocouples. The gripping force was evaluated as well.
Published Version
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
