Abstract
In order to apply plasma actuator to boundary layer transition control, it is necessary to introduce a body force into the appropriate part of the boundary layer, especially near the wall surface. To develop a device that can introduce body force only near the wall surface, we fabricated micro plasma actuators arrays using photolithography, and investigated the generated body force and jet characteristics. Velocity distribution measurements using a hot-wire anemometer were used to analyze the jet characteristics, and the body force distribution of the conventional and micro plasma actuators was clarified.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callMore From: The Proceedings of Mechanical Engineering Congress, Japan
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
