Abstract
In this paper, the potential to utilise modal coupling effects in the formulation of a generalised vibration suppression algorithm is investigated. The plant, a flexible cantilever beam undergoing first mode oscillation, is modelled by a second order differential equation with a spring constant and damping coefficient that are representative of the first mode flexibility and material damping of the beam, respectively. In order to establish an internal resonance condition, a second equation, designated the supplementary equation or controller, is appended to the plant to render a two-degree-of-freedom system. The objective is to generate an internally resonant pair. Upon successful completion of this task, a suppression technique is implemented whereby energy is removed from the plant via the supplementary system. The introduction of the supplementary system results in a set of design parameters which are employed to realise a state of internal resonance and to establish the desired dynamic response. The choice of 2:1 internal resonance models results in a unidirectional control torque making this technique particularly attractive for systems using thrusters or tendons as actuators. A similar structural configuration regulated under a PD (Proportional-Derivative) control law is compared to the proposed control scheme via simulation.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have