Development of a Far-Field Noise Estimation Model for an Aircraft Auxiliary Power Unit

Umair Ahmed,Ian K Jennions,Fakhre Ali

doi:10.1109/access.2021.3112390

Umair Ahmed, Ian K Jennions + Show 1 more

Open Access

https://doi.org/10.1109/access.2021.3112390

Copy DOI

Abstract

Aircraft Auxiliary Power Unit (APU) is one of the major aircraft systems and is reported to be a key driver of unscheduled maintenance. So far, the research has been focused on the implementation of the APU thermodynamic state data to isolate and diagnose faults. To advance the available diagnostic techniques, research work has been initiated to explore the potential of employing far-field microphone data for the identification and isolation of APU faults. This paper aims to address the first step required in the overall effort and proposes a novel methodology for the development of a noise model that can be used for evaluating noise as a source of fault diagnostics. The methodology integrates experimentally acquired full-scale aircraft state and noise data, a physics-based APU thermodynamic model, and semi-empirical noise models to estimate the noise produced by an aircraft APU based on a limited parameter-set. The methodology leads to a model which works by estimating the unknown thermodynamic parameters from the limited dataset and then passes on the relevant parameters to noise estimation models (combustion/jet noise models). An inherent part of the model is the effect of multipath propagation and ground reflections for which a relationship has been analytically derived that considers all the necessary parameters. The developed model has been validated against experimental noise and thermodynamic data acquired from a Boeing 737-400 aircraft APU under several different operating conditions. The acquired noise estimates suggest that the proposed approach provides an accurate estimation of the far-field noise under a wide range of APU operating conditions, both at the sub-system and APU level. The model would act as an enabler to simulate APU noise data under degraded functional states and subsequently developing fault diagnostic schemes based on the far-field noise data.

Highlights

The aircraft is a highly complex and integrated system
The remaining part of the result section will present the outcomes of the noise estimation model
The approach makes use of the open-source thermodynamic modelling package (Toolbox for the Modeling and Analysis of Thermodynamic Systems [T-MATS]) and recommends modification of its turbomachinery blocks to operate in the absence of the components' performance characteristics

Summary

Introduction

The aircraft is a highly complex and integrated system. Amongst, others, one of its major systems, the Auxiliary Power Unit (APU), has been reported as a key driver of unscheduled maintenance and demands a robust maintenance strategy [1]. Performance-based monitoring ( called gas-path analysis) is an example of the prevalent approach for a gas turbine's health monitoring or fault detection [1,2,3,4,5,6,7]. These methods require the installation of thermodynamic sensors which could be intrusive and may not be feasible if they were not considered during the product’s design phase. With the increasing demand for air travel, the desire to reduce aircraft downtime, and the technological advancements made in the relevant fields, the need for state-of-the-art fault diagnostic solutions is increasing. The proposed solutions should be readily deployable and assist in expediting the unscheduled maintenance activities

Objectives

Methods

Results

Conclusion