Development in Lightning Protection of Stations

Abstract

THE AIEE transformer sub-committee has recently sponsored a paper1 on the protection of power transformers against lightning surges. The most effective method given combines overhead ground wires, line entrance gaps, and transformer mounted lightning arresters. Such a method does give a high degree of protection, but it is primarily applicable to high voltage, high capacity stations where the overhead ground wire system is justified for both line and station. The conditions noted above are seldom fulfilled on subtransmission systems from 23 kv to 34.5 kv. Effective ground wires and low ground resistances are uneconomical, and the protection provided is usually a more or less modern arrester, not always located and grounded to the best advantage. On the 23-kv subtransmission system of the Duquesne Light Company, the average transmission distance is approximately two miles. This means that most direct strokes will contact the line not more than one mile from some substation. Much of this transmission is now equipped with wood cross arm braces and guy insulators, and at some stations several spans adjacent thereto are carried on unguyed poles.