Abstract
This article presents the development of a microfluidic valve to be used in capillary flow microfluidic devices. The valve used the principle of electrowetting and was able to be actuated at low voltage. The valve consisted of two inkjet-printed silver electrodes which were encountered in series within a microfluidic channel. The second electrode was modified with a hydrophobic monolayer resulting in a cessation of capillary flow. A potential of 4V resulted in a 70° reduction in apparent water contact angle within 10s which allowed capillary flow to continue. The electrode surface chemistry was investigated prior to monolayer deposition, after monolayer deposition and following the application of the 4V potential. The flexible microfluidic channel consisted of two layers of polyethylene terephthalate bonded by a pressure sensitive adhesive layer which was patterned with a laser ablated microfluidic channel. The final device represented a microfluidic valve for capillary flow microfluidics realized on a flexible substrate. The valve was designed to allow timed fluid delivery for low-cost lab-on-a-chip applications.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callMore From: Colloids and Surfaces A: Physicochemical and Engineering Aspects
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
