Development and simulation studies of an unsteady state biofilter model for the treatment of cyclic air emissions of an α-pinene gas stream

Abstract

This paper describes the development and simulation of an unsteady state biofilter model used to predict dynamic behaviour of cyclically-operated biofilters and compares it with experimental results obtained from three, parallel, bench-scale biofilters treating both periodically fluctuating concentrations and constant concentrations of an α-pinene-laden gas stream. The dynamic model, using kinetic parameters estimated from the constant concentration biofilter, was able to predict the performance of cyclic biofilters operating at short cycle periods (ie, in the order of minutes and hours). Steady state kinetic data from a constant concentration biofilter can be used to predict unsteady state biofilter operation. At a 24 h cycle period, the dynamic model compared well with experimental results. For long cycle periods (ie, hours and days), removal efficiency decreased after periods of non-loading: the longer the period of non-loading, the poorer the biofilter's performance at the re-commencement of pollutant loading. At longer time scales the model did not effectively predict transient behaviour, as adsorption and changes in kinetic parameters were not accounted for. Modelling results showed that similar biofiltration performance for the cyclic and constant concentration biofiltration of α-pinene is expected for biofilters operating solely in the first order kinetics regime. Poorer performance for cyclic biofilters following Monod kinetics spanning the entire kinetics range is expected as the cycle amplitude increases. The most important parameters affecting the performance of a cyclically-operated biofilter with short cycle periods are: amplitude of cyclic fluctuations, Cg, max/Cg, relative value of the half-saturation constant in the Monod expression, Ks, and effective diffusivity of α-pinene in the biofilm, De. Copyright © 2005 Society of Chemical Industry