Development and Production of Artificial Test Swarf to Examine Wear Behavior of Running Engine Components-Part 2: Experimentally Derived Designs.

Abstract

In subtractive manufacturing processes, swarf, burrs or other residues are produced, which can impair the function of a tribological system (e.g., journal bearings). To prevent premature engine damage, cleanliness requirements are defined for production processes. Damaging particle tests are an experimental approach for validating these defined cleanliness requirements. This methodical approach is not yet widely used. For one, the test setup must be developed and proven for the respective application. For another, in order to carry out the tests in a systematic manner, defined test particles with properties similar to those of the contaminants encountered in reality are required. In the second part of the paper, the process chain for manufacturing artificial test swarf by micro powder injection molding (MicroPIM) is described. The size and shape of the swarf were derived from real swarf via several abstraction processes. Although certain design guidelines for MicroPIM parts could not be taken into account, the targeted manufacturing tolerances were achieved in most cases. During demolding, it became apparent that the higher ejection forces of the free-formed geometries must be taken more into account in the design of the mold. The experiments on the test setup also revealed that the artificial test swarf was unexpectedly brittle and was therefore ground up in the bearing gap without causing any substantial damage to the bearing. Thus, the artificial test swarf in its current sintered state is not a suitable substitute for micromilled swarf. However, MicroPIM could still be used to manufacture test particles in applications involving lower mechanical forces.