Development and implementation of a quality control protocol for B-mode ultrasound equipment.

Abstract

Quality assurance (QA) of ultrasound (US) equipment is currently required in only a few countries around the world. In Greece, no national or other norms exist for regulating the use of US equipment. However, to obtain accreditation for the radiology department of a Greek hospital, the establishment and implementation of a quality control (QC) protocol and a QA programme for US equipment was required. A literature review regarding US QC/QA procedures was performed. The information collected was used as a guide to create a QC/QA protocol and to obtain an appropriate US QC phantom. Drafting and testing of the initial protocol lasted 6months. Its final version was implemented for 18months in two US systems and five US transducers. The QC tests included in the protocol evaluate mechanical and electrical safety, image display, uniformity, penetration depth, distance accuracy, greyscale display, anechoic object imaging, geometric distortion, and axial/lateral resolution. The only QC test that failed was the test for uniformity since intense non-uniformities were observed that led to the replacement of two linear transducers. US imaging is considered safe and, where appropriate, is preferred over imaging modalities that use ionizing radiation. However, the lack of QC/QA implies that US image quality is not routinely monitored. Therefore, the possibility of malfunctions that may go undetected and lead to wrong diagnosis cannot be excluded. A QC/QΑ programme can contribute to the elimination of such errors and ensure that performance is maintained over time.