Development and Characterization of Novel Corrosion‐Resistant TWIP Steels

Abstract

AbstractAustenitic steels exhibiting twinning induced plasticity (TWIP) are materials with exceptional mechanical properties. In this work, the development of new grades of TWIP steels exhibiting corrosion resistance is presented. The alloy development was supported by thermodynamic and diffusion calculations within the (FeMnCr)‐(CN) alloy system. For the calculations ambient pressure and primary austenitic solidification were considered as necessary to avoid nitrogen degassing in all processing steps. Manganese is used as an austenite stabilizer, chromium to increase nitrogen solubility and provide corrosion resistance, while carbon and nitrogen provide mechanical strength. Diffusion calculations were used in order to predict the extent of micro segregations and additionally to evaluate the effect of diffusion annealing treatments. The material was cast in a laboratory scale with a nominal composition of Fe‐20Mn‐12Cr‐0.25C‐0.3N. Diffusion annealing was followed by hot rolling and solution annealing resulting in a fully austenitic microstructure. Tensile tests at room temperature were performed, exhibiting yield strengths of 430 MPa and elongation to fracture of 93%. In addition, not only the mechanical properties but also the weldability was studied, focussing on the characterization of the microstructure of bead on plate welds obtained by laser and TIG welding.