Development and Characterisation of Phenolic Resin Moulding Materials for the Production of New Short Fibre-Reinforced C/C-SiC Composites

Abstract

This article focuses on the development of phenolic resin moulding materials for the production of new carbon fibre-reinforced ceramic composite materials based on C/C-SiC by utilising the LSI (liquid silicon infiltration) production method. The production of these moulding materials is being accomplished by combining phenolic resin and carbon fibres with the addition of a few selected parts of processing aids, during which the influence of the used lubricants on the processability of the moulding materials is examined. The starting materials, microstructures and mechanical properties of the materials were characterised at every step of the entire process (CFRP and C/C composites) as well as the end of the whole production (C/C-SiC composites). During this investigation a link between the portions of the lubricant used, the forming of the porosity and the impact on the mechanical properties was discovered. In regards to the optimisation of the process the involved parties were able to determine an optimal lubricant ratio.