Abstract
Horizontal Axis Wind Turbine (HAWT) had been widely used in Malaysia, however, research concluded that the power produced is still low which approximately 0.02% from the wind turbine input is. The average wind speed in Penang, Malaysia, is recorded between 1.0 m/s to 2.5 m/s whereby to produce 2.7 kW of power by HAWT, 12.0 m/s of average wind speed is needed. Therefore, the main objective in this project is to develop and analyse the suitability on the Vertical Axis Wind Turbine (VAWT) to be used for power generation with the wind speed in between 0.5 m/s to 3.0 m/s. Ducting system is chosen rather than the open air since commercial buildings used Heat Ventilation Air Conditioning (HVAC) system. Arduino microcontroller and LabVIEW is used as interfaced to setup two types of sensors that is temperature sensor and anemometer.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callMore From: International Journal of Power Electronics and Drive Systems (IJPEDS)
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
