Abstract
Background/Objectives:The wall climbing robots normally uses suction cups for adhering to the wall surface. The conventional suction cup system using common suction generator suffers from the failure of centralized suction motor. The practically realized climbing robots with on board suction generator are limited with single suction chamber due to load and power limitations. Methods/Statistical analysis: In the proposed work, the climbing robot is realized with two on board suction motors to cater two chambers. Each suction motor is integrated with a suction cup with suitable skirting. A drive system with flat rubber wheels enables the robot to move on smooth surfaces. The design concept of dual suction cup enables safe mobility through adaptive control and ensures the robot functions even any one suction generator fails or encounters higher leakage. This arrangement provides the required negative pressure for cup individually to adhere to the wall. An adaptive control scheme is developed and implemented by interactively controlling the suction cups negative pressure by varying the speed of the corresponding suction motor. This paper also discusses about its basic mathematical analysis, the simulation of the model and the prototype wall climbing robot. Findings: The simulation of the robot is performed using Matlab Simulink Software and also realized with hardware components using an embedded controller, pressure sensors and drive motors. It is observed through simulation that by varying the speed of the suction motor, the negative pressure in the suction cup system can be controlled. The simulation result for the complete holding of the suction cup system considering the frictional forces is found to be -70.25 kPa. The sliding and drop off negative pressure levels by allowing a minimum suction leakage percentage is found by performing simulation. These pressure level values are compared with the experimental suction cup system and found to be closer. Application/ Improvements: The developed climbing robot can be deployed for various inspection tasks of concrete walls, high rise buildings, steel structures etc., The payload capacity of the robot can be still improved by optimizing the pressure levels in the chambers.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
