Development and analysis of a novel printed circuit board electrostatic comb system for micro-newton thrust stand calibration.

Abstract

An electrostatic calibration technique is highly flexible in producing a wide range of force and it is widely applied for nano-newton to micro-newton thrust stand calibration. This paper proposes a novel method for electrostatic comb implementation and related experiments have been carried out. Based on the printed circuit board and commercial fins, the comb can be realized flexibly with the output force conveniently extended. The force generated by this kind of comb is theoretically analyzed. Different from the traditional comb structure, the conductive area of the comb fixed plate is minimized to improve the force consistency over engagement. The influence of fin length, fin number, applied voltage, and engagement on the output force has been studied experimentally. The final comb system is capable of producing steady force in the range 13-5040 μN with the relative error within 5%. With a high voltage pulse generator, this system could produce calibration impulse bit in the range 1-1000 μN s for which the lowest level can be far more extended to the nanonewton range with a shorter pulse width, a lower voltage, and a reduced number of fins. Moreover, the calibrator has a rather flat force-engagement characteristic when the engagement is in the range of 6 mm-16 mm, while the variation of electrostatic force is within 5%. This calibrator has a wide output range and great consistency, and it is beneficial for the thrust stand calibration.