Developing a Control Strategy for Jets in Crossflow Using Direct Numerical Simulation

Abstract

Abstract : Direct numerical simulation is used to study the mixing of a passive scalar by a vortex ring issuing from a nozzle into stationary fluid. The number (Gharib et al 1998), is found to be 3.6. Simulations are performed for a range of stroke ratios encompassing the formation number, and the effect of stroke ratio on entrainment, and mixing is examined. When the stroke ratio is greater than the formation number, the resulting vortex ring with trailing column of fluid is shown to be less effective, at mixing and entrainment. As the ring forms, ambient fluid is entrained radially into the ring from the region outside the nozzle exit. This entrainment stops once the ring forms, and is absent in the trailing column. The rate of change of scalar containing fluid is studied for its dependence on stroke ratio. This rate varies linearly with stroke ratio until the formation number, and falls below the linear curve for stroke ratios greater than the formation number. This behavior is explained by considering the entrainment to be a combination of that due to the leading vortex ring, and that due to the trailing column. For stroke ratios less than the formation number, the trailing column is absent, and the size of the vortex ring increases with stroke ratio, resulting in increased mixing. For stroke ratios above the formation number, the leading vortex ring remains the same, and the length of the trailing column increases with stroke ratio. The overall entrainment decreases as a result.