Abstract
The paper demonstrates deterministic and reliability-based assessment of strength limit states (tensile resistance and pullout) and the service limit state for soil failure for mechanically stabilized earth (MSE) walls constructed with polyester (PET) strap reinforcement. The general approach considers the accuracy of the load and resistance models that appear in each limit state equation plus uncertainty in the estimate of nominal load and resistance values at time of design. Reliability index is computed using a closed-form solution that is easily implemented in a spreadsheet. Three PET strap MSE wall case studies are used to demonstrate the reliability-based assessment approach and to compare margins of safety using different load and resistance model combinations. In some walls using the Coherent Gravity Method to compute loads, the recommended nominal factors of safety for tensile strength and pullout limit states were not satisfied. However, reliability analyses showed that the walls satisfy recommended minimum target reliability index values for the limit states investigated, usually by large amounts. The most critical limit state is the soil failure limit state which is used in the Simplified Stiffness Method to keep the reinforced soil zone at working stress conditions assumed for geosynthetic MSE walls under operational conditions.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have