Determining energy balance in the flaring chromosphere from oxygen V line ratios

Abstract

The impulsive phase of solar flares is a time of rapid energy deposition and heating in the lower solar atmosphere, leading to changes in the temperature and density structure of the region. We use an O V density diagnostic formed of the 192 to 248 line ratio, provided by Hinode EIS, to determine the density of flare footpoint plasma, at O V formation temperatures of 250,000 K, giving a constraint on the properties of the heated transition region. Hinode EIS rasters from 2 small flare events in December 2007 were used. Raster images were co-aligned to identify and establish the footpoint pixels, multiple-component Gaussian line fitting of the spectra was carried out to isolate the diagnostic pair, and the density was calculated for several footpoint areas. The assumptions of equilibrium ionization and optically thin radiation for the O V lines were found to be acceptable. Properties of the electron distribution, for one event, were deduced from earlier RHESSI hard X-ray observations and used to calculate the plasma heating rate, delivered by an electron beam adopting collisional thick-target assumptions, for 2 model atmospheres. Electron number densities of at least log n = 12.3 cm-3 were measured during the flare impulsive phase, far higher than previously expected. For one footpoint, the radiative loss rate for this plasma was found to exceed that which can be delivered by an electron beam implied by the RHESSI data. However, when assuming a completely ionised target atmosphere the heating rate exceeded the losses. A chromospheric thickness of 70-700 km was found to be required to balance a conductive input to the O V-emitting region with radiative losses. The analysis shows that for heating by collisional electrons, it is difficult, or impossible to raise the temperature of the chromosphere to explain the observed densities without assuming a completely ionised atmosphere.