Determining Electro-Osmotic Drag of Water in Anion Exchange Membrane Fuel Cells

Abstract

In an effort to reduce the cost of proton exchange membrane fuel cells (PEMFCs), a significant amount of research into non-precious metal (NPM) oxygen reduction catalysts has been conducted in recent decades. Despite this effort, platinum remains the only material with suitable stability and activity for use in the harsh environment of PEMFCs. Anion exchange membrane fuel cells (AEMFCs) have been gaining increased attention in recent years, providing advantages of higher stability and activity of NPM catalysts in alkaline environments. Unfortunately, the relevant properties, e.g. conductivity and mechanical & chemical stability, of anion exchange membranes (AEMs) are inferior to their proton conducting counterparts. Many studies have been conducted which focus on improving membrane properties such as swelling ratio, conductivity, and stability. In comparison, relatively little attention has been paid to studying ion and water transport in anion exchange membranes. Previous work conducted in our group has indicated that the majority of AEMFC polarization arises from the anode. The performance is relatively insensitive to catalyst loading and initial results indicate that electrode flooding is the primary cause of poor performance. To improve the performance of AEMFCs and better design AEMs, it is therefore important to study the transport of water and ions within AEMs. One key parameter which has received very little attention in the literature is the electro-osmotic transport of water due to the conduction of anions from the cathode to the anode. In this work, we study the electro-osmotic drag (EOD) in anion exchange membranes. The cell design and concept for electro-osmotic drag coefficient (ε) measurements in this work follow from the work of Fuller and Newman as adapted by others1–3. Analysis is conducted on the membranes in pure hydroxide form and carbonate form. The conductivity, water uptake and water mobility of the membranes is also studied over a wide range of relative humidities and temperatures. Better understanding of the transport of water and ions within anion exchange membranes will facilitate the development of models for AEMFC behavior and offer insight for future AEM production. Figure 1: Effect of water activity on the EOD coefficient (ε) and water content (λ) in Tokuyama A201. T. F. Fuller and J. Newman, J. Electrochem. Soc., 139, 1332–1337 (1992).T. A. Zawodzinski, J. Davey, J. A. Valerio, and S. Gottesfeld, Electrochim. Acta, 40, 297–302 (1995).X. Wang, J. P. Mcclure, and P. S. Fedkiw, Electrochim. Acta, 79, 126–132 (2012) http://dx.doi.org/10.1016/j.electacta.2012.06.098. Figure 1