Determining and mapping some soil physico-chemical properties using geostatistical and GIS techniques in the Naqade region, Iran

Abstract

The distribution variability of soil electrical conductivity (EC), pH, clay, sand, CaCO3, organic carbon (OC) and available potassium (K) in the Naqade region was investigated using a geostatistical method and Geographical Information System (GIS) technique. Two hundred and eighty-two topsoil (0–30 cm) samples were randomly collected and analyzed. pH and clay followed a normal distribution, whereas sand EC, CaCO3, OC and K were log-transformed. The highest variation was observed for soil EC, and the lowest for soil pH. In the variography analysis, spherical, exponential and gaussian models were best fit on experimental semivariograms. The minimum effective spatial autocorrelation was 1500 m for OC and the maximum effective spatial autocorrelation was 4000 m for sand and K. Strong spatial correlations were noted with sand and CaCO3 (<25%), whereas values were moderate for clay, EC, OC and K (25–75%). Ordinary kriging was utilized for the interpolation of estimated variable determinations in unsampled sites. It was found that soil properties in this study area were strongly influenced by both environmental and natural factors. The results can be used as a source of information for the development and implementation of any further land management and soil and water conservation plans.