Abstract

BackgroundAchieving Millennium Development Goal 4 is dependent on significantly reducing neonatal mortality. Low birth weight is an underlying factor in most neonatal deaths. In developing countries the missed opportunity for providing life saving care is mainly a result of failure to identify low birth weight newborns. This study aimed at identifying a reliable anthropometric measurement for screening low birth weight and determining an operational cut-off point in the Uganda setting. This simple measurement is required because of lack of weighing scales in the community, and sometimes in the health facilities.MethodsThis was a hospital-based cross-sectional study. Two midwives weighed 706 newborns and measured their foot length, head, chest, thigh and mid-upper arm circumferences within 24 hours after birth.Data was analysed using STATA version 10.0. Correlation with birth weight using Pearson’s correlation coefficient and Receiver Operating Characteristics curve analysis were done to determine the measure that best predicts birth weight. Sensitivity and specificity were calculated for a range of measures to obtain operational cut-off points; and Likelihood Ratios and Diagnostic Odds Ratio were determined for each cut-off point.ResultsBirth weights ranged from 1370–5350 grams with a mean of 3050 grams (SD 0.53) and 85 (12%) babies weighed less than 2500 grams. All anthropometric measurements had a positive correlation with birth weight, with foot length showing the strongest (r = 0.76) and thigh circumference the weakest (r = 0.62) correlations. Foot length had the highest predictive value for low birth weight (AUC = 0.97) followed by mid-upper arm circumference (AUC = 0.94). Foot length and chest circumference had the highest sensitivity (94%) and specificity (90%) respectively for screening low birth weight babies at the selected cut-off points. Chest circumference had a significantly higher positive likelihood ratio (8.7) than any other measure, and foot length had the lowest negative likelihood ratio. Chest circumference and foot length had diagnostic odds ratios of 97% and 77% respectively. Foot length was easier to measure and it involved minimal exposure of the baby to cold. A cut-off of foot length 7.9 cm had sensitivity of 94% and specificity of 83% for predicting low birth weight.ConclusionsThis study suggests foot length as the most appropriate predictor for low birth weight in comparison to chest, head, mid-upper arm and thigh circumference in the Uganda setting. Use of low cost and easy to use tools to identify low birth weight babies by village health teams could support community efforts to save newborns.

Highlights

  • Achieving Millennium Development Goal 4 is dependent on significantly reducing neonatal mortality

  • A third of all neonatal deaths occur in Sub-Saharan Africa, where neonatal mortality rate (NMR) is 35/1000 live births

  • These trends in NMR indicate that Millennium Development Goal 4 will not be achieved unless deliberate efforts are directed towards reducing deaths during the neonatal period

Read more

Summary

Introduction

Achieving Millennium Development Goal 4 is dependent on significantly reducing neonatal mortality. This study aimed at identifying a reliable anthropometric measurement for screening low birth weight and determining an operational cut-off point in the Uganda setting. According to the Uganda Demographic and Health Survey 2011 preliminary report, NMR decreased from 36 to 27/1000 live births over the last 10 years but the proportion of infants that die during the neonatal period increased from 37% to 50% in the same period (UBOS & MEASURE). These trends in NMR indicate that Millennium Development Goal 4 will not be achieved unless deliberate efforts are directed towards reducing deaths during the neonatal period. The leading causes of neonatal mortality are complications of preterm births, intra-partum related complications and infections namely sepsis and pneumonia [2]

Objectives
Methods
Results
Conclusion

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call

Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.